[Commercial meshers] how to mesh structured o-grid in icem cfd

mahesh n · December 30, 2014, 06:13

hi some one please help me out how to mesh between matting surfaces of cylinder and rectangle as show in image...

roadRunner · April 20, 2015, 07:45

Your picture is not very clear, but if I see correctly, rectangle is tangent to the circle? That cannot work IMHO.

Did you checkout the tutorials? There is a nice example for this.
Ogrid only splits existing blocks, so I suggest splitting the blocks around the circle first, so that you get circle inside the rectangle, and then apply ogrid to that.

But look at the tutorials, there is a nice example there on Ogrid usage.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre	powpow	CFX	3	December 20, 2012 09:14
[ICEM] Structured mesh inflation using ICEM ANSYS CFD	francis1	ANSYS Meshing & Geometry	3	August 13, 2012 22:58
Transport mesh from ICEM CFD, to Fluent, to Sysnoise	Wieland	FLUENT	2	April 15, 2012 06:28
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 19:04
ICEM CFD 5.1 Hex-Tet mesh merging failure	bogesz	CFX	1	January 29, 2005 06:46

April 20, 2015, 07:45		#2
roadRunner Member Join Date: Apr 2015 Location: EU Posts: 38 Rep Power: 11	Your picture is not very clear, but if I see correctly, rectangle is tangent to the circle? That cannot work IMHO. Did you checkout the tutorials? There is a nice example for this. Ogrid only splits existing blocks, so I suggest splitting the blocks around the circle first, so that you get circle inside the rectangle, and then apply ogrid to that. But look at the tutorials, there is a nice example there on Ogrid usage.