|October 1, 2009, 10:21||
when mesh big......incorrect orientation to set wrongOrientedFaces???
Join Date: Mar 2009
Location: OvgU, Magdeburg
Posts: 65Rep Power: 7
I am still using 1.5-dev, because the we failed in installing 1.6 on cluster.
I set up a mesh on Gambit in 3D, and convert it into OpenFOAM,
when my .msh is relatively small, it is fine: but when I increase the mesh points on some lines in the .jou, and run the journal then convert to OF again, my mesh can't pass checkMesh:
" ***Error in face pyramids: 24 faces are incorrectly oriented.
<<Writing 24 faces with incorrect orientation to set wrongOrientedFaces"
I have try the the method suggested by prof. Jasak, "read into Fluent, then write out", but in most cases, it doesn't work.
Can you give me some idea?
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Set a set of circular initial conditions on a mesh||jinwon park||Main CFD Forum||0||January 26, 2008 12:10|
|Convergence moving mesh||lr103476||OpenFOAM Running, Solving & CFD||30||November 19, 2007 15:09|
|How to set environment variables||kanishka||OpenFOAM Installation||1||September 4, 2005 11:15|
|General questions on grid-based computing||Adrin Gharakhani||Main CFD Forum||21||June 5, 2000 14:47|
|unstructured vs. structured grids||Frank Muldoon||Main CFD Forum||1||January 5, 1999 11:09|