|
[Sponsors] |
[Gmsh] Problems when importing file from gmsh to OpenFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 20, 2019, 11:00 |
Problems when importing file from gmsh to OpenFoam
|
#1 | |
New Member
Sebastian Tietjen
Join Date: Sep 2019
Posts: 1
Rep Power: 0 |
Hi guys,
I hope this is the right category. This is my first post in this forum, but hopefully you can help me with that problem. I created a mesh with gmsh which follows a hyperbolic-tangent-function in two directions and in the third directions a equidistant meshing (see file attached). If I mesh it in Gmsh everything works fine. However, importing the mesh to OpenFoam some errors which I do not get. Firstly, I tried to import the mesh with the actual number of nodes, where the gmsh crashed when generating the mesh in 3D. Then, I reduced the nodes and I got this error: Quote:
I would be pleased about any help thanks a lot! - Sebastian |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[waves2Foam] Tripping over several build issues with OpenFOAM 2.1.1 | Yage | OpenFOAM Community Contributions | 18 | February 15, 2016 02:02 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |