|October 30, 2010, 11:14||
problem in converting mesh from fluent
Hi Foamers please help me out
i am converting fluent.msh to OF 1.6.
by command fluentMeshtoFoam -scale 0.001
then its extruding 8.9 mm in z direction.
so how could i convert this 8.9 mm to 1 mm thickness.
plese help me out.
|November 2, 2010, 17:25||
is this a 2 or 3d mesh?
Daniel P. Combest
Join Date: Mar 2009
Location: St. Louis, USA
Posts: 585Rep Power: 20
More info about your problem would be helpful. if this a 2D mesh or a 3D mesh? if it is a 2D mesh then OF adds another dimension that you can set the front and back of the mesh as an empty boundary condition. without more info I can't help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|Problem with 2D ICEM mesh check in fluent||Nicola||FLUENT||3||March 25, 2013 06:56|
|gmshToFoam problem: not the same mesh in Gmsh vs. paraview||zhernadi||Open Source Meshers: Gmsh, Netgen, CGNS, ...||8||July 7, 2011 02:28|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|
|A problem about Importing mesh from fluent||aderliner||OpenFOAM Running, Solving & CFD||0||December 19, 2006 00:05|