|
[Sponsors] |
[Commercial meshers] problem in converting mesh from fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 30, 2010, 11:14 |
problem in converting mesh from fluent
|
#1 |
Member
|
Hi Foamers please help me out
i am converting fluent.msh to OF 1.6. by command fluentMeshtoFoam -scale 0.001 then its extruding 8.9 mm in z direction. so how could i convert this 8.9 mm to 1 mm thickness. plese help me out. Regards Ambilpur Kiran |
|
November 2, 2010, 16:25 |
is this a 2 or 3d mesh?
|
#2 |
Senior Member
Daniel P. Combest
Join Date: Mar 2009
Location: St. Louis, USA
Posts: 621
Rep Power: 0 |
More info about your problem would be helpful. if this a 2D mesh or a 3D mesh? if it is a 2D mesh then OF adds another dimension that you can set the front and back of the mesh as an empty boundary condition. without more info I can't help.
Dan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |