 |
 |
 |
|
|
|
[Sponsors] | ||||
December 28, 2010, 01:37
|
about dynamic mesh?????
|
#1 |
|
New Member
Abusha
Join Date: Dec 2010
Posts: 2
Rep Power: 0  |
I am trying to simulate twin screw pump by using ANSYS-FLUENT and I used dynamic mesh but I have a problem when I preview mesh motion and I got negative volume. before that I used ANSA for intial meshing of the model I think I have to smoothing the mesh but I couldn't, please can you suggest me how can I have to solve it and if you know any other refference on screw pump simulation please tell me.
Thank you!!! |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
| Sliding / Dynamic Mesh in heat transfer problem | platzhalter | FLUENT | 0 | May 7, 2018 05:25 |
| [ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 04:19 |
| Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 22:09 |
| dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 08:03 |
Linear Mode
