|November 24, 2011, 16:35||
Special tricks for MRF meshes in ICEM
Join Date: Mar 2009
Posts: 355Rep Power: 8
I'm going to do a simulation of a fan, what means 2 stationary and a rotating domain between them. I will create the mesh in ICEM cfd, and then convert it to OF, but what I'm interested in is that the tricks and methods in order to make the mesh work in OF. For example I think of the special meshing of the interfaces (do I need duplicate surfaces there or only one) and so on.
Every suggestion is very welcome in this topic, I hope it would be helpful for the others too.
CFD= Cleverly Formatted Data
|icem cfd, meshing, mrf, turbomachinery|
|Thread||Thread Starter||Forum||Replies||Last Post|
|PEM Fuel cell module meshes. ICEM vs workbench||aarvay||FLUENT||16||September 15, 2014 10:21|
|[ICEM] Shadow walls in Fluent. ICEM meshes vs Workbench||aarvay||ANSYS Meshing & Geometry||10||February 5, 2014 12:17|
|Different results from similar quality cfx and ICEM meshes||Nick R||CFX||3||January 17, 2011 08:48|
|Problem exporting big meshes from ICEM to Fire||Emil||CFX||0||October 10, 2008 13:06|
|Joining Meshes in Ansys ICEM CFD||Amitava Guha||FLUENT||2||April 22, 2008 13:35|