|
[Sponsors] |
[Commercial meshers] checkmesh => Open cells found, max cell openness |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 22, 2011, 10:05 |
checkmesh => Open cells found, max cell openness
|
#1 |
Senior Member
joegi
Join Date: Nov 2009
Location: genoa
Posts: 102
Rep Power: 16 |
Hi,
I wonder what is the meaning of the following message: ***Open cells found, max cell openness: 0.0218725, number of open cells 1830 <<Writing 1830 non closed cells to set nonClosedCells I am getting this message on a polyhedral mesh, which btw works fine on fluent. What can I do to fix this error? Regards, Joel |
|
June 3, 2012, 17:35 |
|
#2 |
Member
HD
Join Date: Jul 2011
Posts: 56
Rep Power: 14 |
Hi Joel,
I got the same problem as well. Have you solved yours? If so, could you give me some directions? Thank you very much. Best, Hang |
|
June 4, 2012, 09:17 |
|
#3 |
Senior Member
joegi
Join Date: Nov 2009
Location: genoa
Posts: 102
Rep Power: 16 |
Hi,
Well, so far I haven't figure out what is the problem. For simple polyhedral meshes it works fine, but when I use complex geometries it always gives me this problem. So I decided not to use polyhedral meshes on complex geometries, and honestly speaking I don't use polyhedral meshes I just was testing OpenFOAM ability to handle them. jg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
SparceImage v1.7.x Issue on MAC OS X | rcarmi | OpenFOAM Installation | 4 | August 14, 2014 06:42 |
Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 02:53 |