 |
 |
 |
|
|
|
[Sponsors] | ||||
August 22, 2012, 00:49
|
refineMesh Cylinder
|
#1 |
|
Member
Norbert Weber
Join Date: May 2012
Location: Dresden, Germany
Posts: 37
Rep Power: 13  |
I would like to refine a blockmesh. But only an inner cylindrical part. In my opinion, refineMesh does not work properly, because it connects some cells wrong (see picture). Has anyone had the same problem and/or can suggest a solution?
|
|
|
|
|
|
August 22, 2012, 04:38
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Posts: 113
Rep Power: 15 |
If you switch of "decompose polyhedral cells" in paraview, it will look nicer. But you can trust the refineMesh - the mesh is ok. Or did checkMesh complain about something?
Greetings |
|
|
|
|
|
|
August 22, 2012, 06:43
|
|
#3 |
|
Member
Norbert Weber
Join Date: May 2012
Location: Dresden, Germany
Posts: 37
Rep Power: 13 |
CheckMesh does not complain, so probably you are right. But it is still strange, why some cells are drawn wrong.
|
|
|
|
|
|
|
August 22, 2012, 08:38
|
|
#4 |
|
Senior Member
Join Date: Nov 2010
Posts: 113
Rep Power: 15 |
As said, try to look at it with the option "decompose polyhedral cells".. It'll look fine then..
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flow past a 2D cylinder - High Re (1E+05) - Cd too high | Pervispasco | OpenFOAM Running, Solving & CFD | 4 | March 14, 2022 02:19 |
| Drag force coefficient too high for a flow past a cylinder using komega sst | Scabbard | OpenFOAM Running, Solving & CFD | 37 | March 21, 2016 16:16 |
| Forces Acting on a Rotating Cylinder (Moving Mesh) | dreamchaser | CFX | 5 | April 25, 2015 06:01 |
| Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
| [blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
Linear Mode
