 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Can't get simple STL file to mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 25, 2012, 18:09
|
Can't get simple STL file to mesh
|
#1 |
|
New Member
Adam Preece
Join Date: Jun 2012
Location: Oxfordshire, UK
Posts: 2
Rep Power: 0  |
My intention is to set-up an aerofoil (original I know!) using snappyHexMesh but I'm having no end of trouble. I've attached a very basic STL file which I've tried to import but I get the error:
--> FOAM FATAL ERROR: Faces do not seem to be correct across coupled boundaries Coupled face 9497282 on patch 0 allBoundary coords:4((-0.97 0.1 -0.09) (-0.97 0.1 -0.085) (-0.965 0.1 -0.085) (-0.965 0.1 -0.09)) has face area:2.5e-05 (coupled) neighbour face area differs:1.25e-05 to within tolerance 2.24499e-06 From function hexRef8::checkMesh() in file polyTopoChange/polyTopoChange/hexRef8.C at line 4489. FOAM aborting I've had some success with a sphere imported from STL but no joy with this rough wing section. Any help would be appreciated! |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
Linear Mode
