|August 24, 2012, 14:18||
snappyhexmesh refinement stops when?
Join Date: Apr 2010
Blog Entries: 1Rep Power: 7
Assuming I defined both surface shell based refinement and region - volumetric - refinement.
If the maximum number of cells is reached during surface based refinement, region refinement will not occur anymore, in essence leaving you with a mesh with large cells away from surfaces.
Is that so?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Adding layers goes wrong with SnappyHexMesh||Elise||OpenFOAM Native Meshers: snappyHexMesh and Others||1||April 22, 2013 02:32|
|snappyHexMesh refinement regions ignored||guitarbren||OpenFOAM Meshing & Mesh Conversion||2||April 9, 2013 03:59|
|killed "snappyHexMesh"||parkh32||OpenFOAM Pre-Processing||2||April 8, 2012 17:12|
|snappyHexMesh won't work - zeros everywhere!||sc298||OpenFOAM Native Meshers: snappyHexMesh and Others||2||March 27, 2011 21:11|
|snappyHexMesh aborting||Tobi||OpenFOAM Native Meshers: snappyHexMesh and Others||0||November 10, 2010 04:23|