CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [snappyHexMesh] when it comes to layer addition, snaped edges becomes reset (https://www.cfd-online.com/Forums/openfoam-meshing/108449-when-comes-layer-addition-snaped-edges-becomes-reset.html)

nille_furtado October 24, 2012 06:41

when it comes to layer addition, snaped edges becomes reset
 
2 Attachment(s)
A few days ago I posted the following text in a different thread, but got no reply. So perhaps a new thread would help me. I tried a lot, but the snapped edges are always merged back!

Hi everyone,
I've got a problem with my layer addition in SHM. I've read a lot about the whole topic, but never heard something about this problem. Perhaps you could help me out.
I am meshing a wind turbine an therefore used SHM, especially the new snapEdge feature of SHM (nFeatureSnapIter 20). The results for time 2 are very good, but when it comes to layer addition, some "undo"-iterations occur which destroy some of the snapped edges


All times are GMT -4. The time now is 19:59.