|October 24, 2012, 05:41||
when it comes to layer addition, snaped edges becomes reset
Join Date: Oct 2012
Posts: 2Rep Power: 0
A few days ago I posted the following text in a different thread, but got no reply. So perhaps a new thread would help me. I tried a lot, but the snapped edges are always merged back!
I've got a problem with my layer addition in SHM. I've read a lot about the whole topic, but never heard something about this problem. Perhaps you could help me out.
I am meshing a wind turbine an therefore used SHM, especially the new snapEdge feature of SHM (nFeatureSnapIter 20). The results for time 2 are very good, but when it comes to layer addition, some "undo"-iterations occur which destroy some of the snapped edges
|Thread||Thread Starter||Forum||Replies||Last Post|
|engineFoam with layers - pressure problems when adding layers||mturcios777||OpenFOAM Running, Solving & CFD||22||October 17, 2013 02:52|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 09:54|
|snappyHexMesh won't work - zeros everywhere!||sc298||OpenFOAM Native Meshers: snappyHexMesh and Others||2||March 27, 2011 21:11|
|Boundary layer generation problems||ivan_cozza||OpenFOAM Native Meshers: snappyHexMesh and Others||0||October 6, 2010 13:47|
|errors||Fahad||Main CFD Forum||0||March 23, 2004 14:20|