CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[mesh manipulation] How to run only a subset of your Mesh ?

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 23, 2013, 21:39
Default How to run only a subset of your Mesh ?
  #1
New Member
 
Emil
Join Date: Feb 2013
Posts: 5
Rep Power: 13
NewOFer is on a distinguished road
I am new to OpenFoam,

I have a Mesh (representing 2 layers) and a running model.
I would like to run the model in 2 phases.
Phase 1 : Make bottom layer inactive and I only run the top layer
Phase 2 : Make the top layer inactive and continue running with end of phase 1 as boundary conditions for the topwall.

Is there a way to inactivate a set of cells of the Mesh ?
How do you do that ? And what about the Boundary conditions ?

Thank you
NewOFer is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 15 November 18, 2020 07:09
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! divergence OpenFOAM Meshing & Mesh Conversion 0 January 23, 2019 05:17
[snappyHexMesh] Snappyhex mesh: poor inlet mesh Swagga5aur OpenFOAM Meshing & Mesh Conversion 1 December 3, 2016 17:59
CFX FSI Fatal Error unbanana CFX 0 October 3, 2015 06:57
3D Hybrid Mesh Errors DarrenC ANSYS Meshing & Geometry 11 August 5, 2013 07:42


All times are GMT -4. The time now is 07:44.