|July 19, 2013, 08:39||
SnappyHexMesh -- Giving Up -- Reason
Join Date: May 2013
Location: Munich Germany
Posts: 27Rep Power: 3
I am trying to mesh the geometry of a centrifugal blower. I am having trouble with snappy saying that it "cannot sap successfully .. Giving up". I could not figure out what is happening.
I read a lot of discussion about this problem in the thread ....
Also in the snappy hex mesh log I found that the given point is found in cell number -1 of the region 0 of 4 ...
Is it a problem I meant ... -1 cell ...??
But this is not the case in the beginning ... !! this cell number was a positive number in the beginning .. !! later it is -1 ... !!
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|snappyhexmesh: Running out of memory (without reason?)||marco.müller||OpenFOAM Native Meshers: snappyHexMesh and Others||24||January 10, 2015 10:34|
|Scaling and SnappyHexMesh||kingmaker||OpenFOAM Pre-Processing||3||July 15, 2013 09:05|
|Strange Results With snappyHexMesh||calebamiles||OpenFOAM Running, Solving & CFD||0||August 14, 2011 16:02|
|stitchMesh and snappyHexMesh||gdbaldw||OpenFOAM||0||December 23, 2009 03:09|
|Discussion: Reason of Turbulence!!||Wen Long||Main CFD Forum||3||May 15, 2009 09:52|