|
[Sponsors] |
[snappyHexMesh] Explain the snapping process. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 6, 2014, 03:24 |
Explain the snapping process.
|
#1 |
New Member
avinashjagdale
Join Date: Feb 2014
Location: pune,India
Posts: 26
Rep Power: 12 |
Can anyone explain the snapping process along with the associated SnapControls?
The info in user guide is too little to get an insight, for a beginner like me. |
|
March 8, 2014, 02:52 |
|
#2 |
Member
Pekka Pasanen
Join Date: Feb 2012
Location: Finland
Posts: 87
Rep Power: 14 |
Have a look at this pdf, which is a very comprehensive guide to snappyHexMesh. You can safely ignore the parts about HelyxOS if you don't use it.
http://www.hpc.cineca.it/sites/defau...ys-HELYXOS.pdf |
|
March 9, 2014, 03:53 |
|
#3 |
New Member
avinashjagdale
Join Date: Feb 2014
Location: pune,India
Posts: 26
Rep Power: 12 |
@zordiack I have already gone through it. But sadly it has just two slide for explaining snapping process uner snapcontrols. I am not being able to understand clearly what the parameters there means. I have understood castellated process. Just like that ,they don't seem to have given indepth what actually happens under snapcontrol.
|
|
March 10, 2014, 09:21 |
|
#4 |
Senior Member
Join Date: Mar 2010
Location: Germany
Posts: 154
Rep Power: 16 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Process xxxx: received signal SIGSEGV; The fl process could not be started | Someeee | FLUENT | 1 | October 31, 2018 04:32 |
error 262144 and unexpected disconnect when run on 2 nodes | Emily1412 | SU2 Installation | 1 | April 10, 2014 17:08 |
[snappyHexMesh] Snapping not enough (even with surfaceFeatureExtract) | ironclad | OpenFOAM Meshing & Mesh Conversion | 1 | November 8, 2013 02:58 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |
Coupling of drying process and flow simulation | franzdrs | Main CFD Forum | 0 | April 29, 2013 14:11 |