|March 16, 2014, 05:39||
snappyHexMesh uses tet cells for internal mesh!
Join Date: Sep 2012
Location: Iran - Tehran
Posts: 185Rep Power: 4
I have a question about snappyhexmesh. Actually I have used this utility several times. I think it is possible to create hexa cells on boundary faces but for internal mesh this utility uses tetra cells. For example, Take a look at igloo test case (version 2.2.2). There are some hexa cells on boundary faces (picture1) but when I create a slice I can not find any hexa cells!!!(picture2) (Please correct me if I am wrong). How can I create hexa cells for internal mesh by using snappyhexmesh ?
I appreciate your help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|snapEdge - failure||Tobi||OpenFOAM Native Meshers: snappyHexMesh and Others||33||March 18, 2014 04:58|
|how to set periodic boundary conditions||Ganesh||FLUENT||13||January 22, 2014 05:11|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 09:54|
|snappyHexMesh not refining surfaces||Hydro1004||OpenFOAM||3||August 29, 2012 11:56|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|