|April 24, 2014, 23:14||
DAT file from Salome for use with Foam.
Join Date: May 2013
Posts: 74Rep Power: 4
I used Salome to generate a mesh and sent it to a dat file, mainly because the unv format would lose triangles. Basically I then tried using datToFoam
but I got this error?
--> FOAM FATAL IO ERROR: wrong token type - expected word, found on line 0 the label 1 file: IStringStream.sourceFile at line 0. From function operator>>(Istream&, word&) in file primitives/strings/word/wordIO.C at line 74. FOAM exiting
|dat file, mesh, salome|
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4foam building problem||GGerber||OpenFOAM Installation||54||April 24, 2015 16:02|
|how to calculate mass flow rate on patches and summation of that during the run?||immortality||OpenFOAM Post-Processing||82||November 25, 2014 14:16|
|Errors during blockMesh meshing||Madeleine P. Vincent||OpenFOAM Native Meshers: blockMesh||43||February 18, 2014 03:42|
|simpleFoam parallel||AndrewMortimer||OpenFOAM Running, Solving & CFD||10||November 12, 2013 18:03|
|Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12||keepfit||OpenFOAM Paraview & paraFoam||60||September 18, 2013 03:23|