Boundary layer
I used snappyHexMesh to create these two meshes:
http://postimg.org/image/4c7xslwb3/1 layer BL: http://postimg.org/image/l39sfladl/http://s27.postimg.org/su81jxgin/1layer.jpg 2 layers BL: http://s15.postimg.org/ur32tpo47/2layer.jpg I used featureAngle = 180 in both cases. Could you please tell me which parameter I should change to avoid the problems with 2 layers BL creation? doodek |
Hello doodek,
Try first nGrow = 0 If you still have problem, try to relax the mesh quality parameters during layers creation (see Post #3 in this thread). Regards, Eloïse |
All times are GMT -4. The time now is 14:03. |