[snappyHexMesh] Problemetic Mesh -- CFD Online Discussion Forums

July 27, 2014, 11:36

Problemetic Mesh

mwaqas

Senior Member

Muhammad Waqas

Join Date: Jul 2014

Location: Germany

Posts: 122

Rep Power: 11

Hi everyone
I am using snappyHexMesh for meshing. I did meshig, it is working fine. But there are some bad sectors in mesh as you can see in fig. can you please tell how can I remove these bad sectors

Attached Images

cylinder mesh.jpg (72.3 KB, 21 views)

August 4, 2014, 08:26		#2
Mashiro5 New Member Stefano Gaggero Join Date: Mar 2013 Posts: 23 Rep Power: 13	Maybe the bad cells are only visualization issues (especially if what you are visualizing is a section or a clip..)? Have you tried to enable VTKPolyhedron in Paraview? mwaqas likes this.

August 4, 2014, 11:54		#3
mwaqas Senior Member Muhammad Waqas Join Date: Jul 2014 Location: Germany Posts: 122 Rep Power: 11	Hello Mashiro5 Thank you for your reply. Yes you are right it was only visualization problem

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Star CCM Overset Mesh Error (Rotating Turbine)	thezack	Siemens	7	October 12, 2016 11:14
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

All times are GMT -4. The time now is 07:47.