|
[Sponsors] |
[blockMesh] blockMesh error with 6 HEX blocks |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 5, 2014, 03:03 |
blockMesh error with 6 HEX blocks
|
#1 | |
Member
Join Date: Nov 2009
Posts: 65
Rep Power: 16 |
Dear all,
I'd like to run a flow simulation around a very simple obstacle in a duct (2D), like an attached figure. I wrote blockMeshDict and had a error when I run blockMesh command with the attached simple blockMeshDict (on OF 2.3.x) . What's wrong in this blockMeshDict? Thanks in advance waku2005 error: Quote:
|
||
September 13, 2014, 15:37 |
|
#2 |
New Member
Join Date: Jul 2014
Posts: 22
Rep Power: 11 |
Hello,
your error code says, that you are defining an internal face, so your Wing is completly in your blockMesh. If you don't want that, you have to adapt your hex blocks or if you don't need initial conditions for the wing, just uncomment your two faces in the wing boundary. Kind regards, Mike |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face | A.A. | OpenFOAM Meshing & Mesh Conversion | 41 | June 26, 2020 07:06 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
[Other] mergeMatchPairs with arcs | vainilreb | OpenFOAM Meshing & Mesh Conversion | 1 | August 5, 2013 08:11 |
[blockMesh] apparently the mesh doesn't want to be created in one direction | Maxime Thomas | OpenFOAM Meshing & Mesh Conversion | 1 | August 18, 2012 06:05 |
CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 02:34 |