|
[Sponsors] |
[snappyHexMesh] Weird boundaryLayer additional faces at wall |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 29, 2015, 04:56 |
Weird boundaryLayer additional faces at wall
|
#1 |
New Member
Join Date: Feb 2015
Posts: 18
Rep Power: 11 |
Hi everyone,
I'm meshing a motorboat with a relative compelx geometry. I've been working on this quiet hardly to get nice and continuous boundary layer along the hull. However, I'm not growing boundary layer mesh at some specific patch to save cells. I just came accross a very weird defect. If I visualize the hull, I can see some kind of flaps made of the face of the boundary layer, at the junction of a patch where there is no BL mesh. I think a picture is better than words so please see attached pictures. My worry is that those face are suppose to be internal cell (so inside the fluid), I'm worried that there may be no flux through those face. Any idea where it can come from? Thx for your help Jordan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Layers not growing at all | zonda | OpenFOAM Meshing & Mesh Conversion | 12 | June 6, 2020 11:28 |
parallel run OpenFoam | Srinath Reddy | OpenFOAM Running, Solving & CFD | 13 | February 27, 2019 09:15 |
GenerateVolumeMesh Error - Surface Wrapper Self Interacting (?) | AndreP | STAR-CCM+ | 10 | August 2, 2018 07:48 |
[snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
foam-extend_3.1 decompose and pyfoam warning | shipman | OpenFOAM | 3 | July 24, 2014 08:14 |