 |
 |
 |
|
|
|
[Sponsors] | ||||
October 16, 2015, 11:12
|
snappy in 2.5 D
|
#1 |
|
New Member
Join Date: Oct 2015
Posts: 2
Rep Power: 0  |
How do I configure snappyHexMesh to produce mesh's with one element in a direction ?
Eg. I'm meshing a Cylinder and i only want a '2 dimensional' mesh |
|
|
|
|
|
October 16, 2015, 11:27
|
|
#2 |
|
Senior Member
Niels Gjoel Jacobsen
Join Date: Mar 2009
Location: Copenhagen, Denmark
Posts: 1,900
Rep Power: 37 |
Good evening,
Simply use the extrudeMesh functionality on one of the boundaries in the empty direction after snappyHexMesh. Kind regards, Niels
__________________
Please note that I do not use the Friend-feature, so do not be offended, if I do not accept a request. |
|
|
|
|
|
|
October 16, 2015, 11:34
|
squash em
|
#3 |
|
New Member
Join Date: Oct 2015
Posts: 2
Rep Power: 0 |
That was quick, thanks. I think i'll go squash a few mesh's.
|
|
|
|
|
|
|
October 17, 2015, 18:21
|
|
#4 |
|
Senior Member
Paulo Vatavuk
Join Date: Mar 2009
Location: Campinas, Brasil
Posts: 196
Rep Power: 17 |
Hi molekel,
In the link below there is a nice tutorial that explains Niels suggestion. https://www.hpc.ntnu.no/display/hpc/...llway+Tutorial Best regards, Paulo |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error while running pisoFoam with snappy but ran smoothly without snappy in empty dm | faiazk | OpenFOAM Running, Solving & CFD | 0 | October 24, 2018 13:51 |
| [snappyHexMesh] Bad snappy - an igloo challenge | GerhardHolzinger | OpenFOAM Meshing & Mesh Conversion | 0 | January 24, 2016 10:10 |
| [blockMesh] Another cylinder question | bendel_boy | OpenFOAM Meshing & Mesh Conversion | 5 | January 6, 2015 05:09 |
| icoFoam continuity error | tellico | OpenFOAM | 1 | September 21, 2011 03:43 |
| weird error during blockMesh | SePe | OpenFOAM | 1 | October 25, 2010 10:31 |
Linear Mode
