|August 8, 2016, 08:54||
Multi region meshing with SHM creates extra regions
Join Date: Jul 2016
Posts: 1Rep Power: 0
I'm trying to mesh a heat exchanger with SHM and whenever i try to rifne the mesh I get extra regions named domain0 ,domain1 and so on. I figured it out that the number of these extra regions depends on the refinement level.
The STL I use is imported from Inventor
I gladly welcome any tip/solution idea about this issue.
|chtmultiregion, domain, shm|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Part based meshing VS Region based meshing||Bharatt||STAR-CCM+||3||November 20, 2015 02:06|
|Multi Region Meshing||bruce||OpenFOAM Native Meshers: snappyHexMesh and Others||12||July 31, 2013 10:09|
|Using starToFoam||clo||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||33||September 26, 2012 04:04|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|
|Import gmsh msh to Foam||adorean||Open Source Meshers: Gmsh, Netgen, CGNS, ...||24||April 27, 2005 08:19|