 |
 |
 |
|
|
|
[Sponsors] | ||||
[Commercial meshers] when mesh big......incorrect orientation to set wrongOrientedFaces??? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 1, 2009, 09:21
|
when mesh big......incorrect orientation to set wrongOrientedFaces???
|
#1 |
|
Member
Hai Yu
Join Date: Mar 2009
Location: Harbin
Posts: 67
Rep Power: 17  |
hi~
I am still using 1.5-dev, because the we failed in installing 1.6 on cluster. I set up a mesh on Gambit in 3D, and convert it into OpenFOAM, when my .msh is relatively small, it is fine: but when I increase the mesh points on some lines in the .jou, and run the journal then convert to OF again, my mesh can't pass checkMesh: " ***Error in face pyramids: 24 faces are incorrectly oriented. <<Writing 24 faces with incorrect orientation to set wrongOrientedFaces" I have try the the method suggested by prof. Jasak, "read into Fluent, then write out", but in most cases, it doesn't work. Can you give me some idea? Thanks in advance. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 09:53 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Linear Mode
