 |
 |
 |
|
|
|
[Sponsors] | ||||
April 9, 2009, 16:55
|
snappyHexMesh createPatch cellLevel
|
#1 |
|
Member
Ulrich Heck
Join Date: Mar 2009
Location: Krefeld, Germany
Posts: 36
Rep Power: 6  |
Hi,
I actually work with snappyHexMesh. The mesh generation works fine but afterwards I would like to merge some patches. I do this with createPatch (construct from patches) and createPatch merges the patches in “boundary” but not in the cellLevel and pointLevel files. This causes some issues when I try to start the case. Any idea how the patches can be merged easily in these two files (cellLevel/pointLevel) according to the merged patches in the boundary-definition? Thanks in advance Ulrich |
|
|
|
|
|
October 1, 2009, 10:23
|
|
#2 |
|
Senior Member
Philip Cardiff
Join Date: Mar 2009
Location: Dublin,Ireland
Posts: 426
Rep Power: 9 |
Hi,
you could try the utility in OpenFOAM-1.4 called 'patchTool'. It's a GUI utility which, as the name suggests, can create/merge/manipulate patches/and more. Philip |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SnappyHexMesh with local refinement of ONE STLfile | wolle1982 | OpenFOAM Mesh Utilities | 14 | March 24, 2012 17:33 |
| SnappyHexMesh and Snapping | thomasr | OpenFOAM Mesh Utilities | 5 | March 15, 2012 12:07 |
| Parallel case setup boundry conditions snappyhexmesh | oskar | OpenFOAM Pre-Processing | 5 | September 11, 2009 01:12 |
| SnappyHexMesh in 2D case | sjs | OpenFOAM Mesh Utilities | 9 | July 8, 2009 17:42 |
| SnappyHexMesh not generate mesh first time | mavimo | OpenFOAM Mesh Utilities | 4 | August 26, 2008 07:08 |
Linear Mode
