|November 30, 2010, 11:02||
incompleted faceZones ? normal?
Join Date: Oct 2010
Location: Leoben (Austria)
Blog Entries: 6Rep Power: 26
meshing a length of a pipe with snappyHexMesh.
So everything is working but i am not sure if the faceZones could have those gaps or if this is normal? The simulation is running and the solver also runs but i don't know if those gaps manipulate the result.
Here the mesh after meshing:
FaceZones - Incomplet / with gaps:
Last Picture - all three faceZones activated - and the gaps from one faceZone is filled with the other one. But if i generate the same mesh with blockMesh i've got no gaps.
How can i reduce the gaps ?
And are they manipulating my result while solving?
Hope someone can help me.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF to Access Wall Normal Concentration Gradient||Daniel Tanner||Fluent UDF and Scheme Programming||4||February 18, 2015 15:35|
|my stl surface is seen as just a line||rcastilla||OpenFOAM Meshing & Mesh Conversion||2||January 6, 2010 02:30|
|Normal stress?/||bowlderyu||Main CFD Forum||1||October 28, 2008 22:57|
|NACA0012 geometry/design software needed||Franny||Main CFD Forum||13||July 7, 2007 15:57|
|How to get normal vector to the face?||Viatcheslav Kulikov||FLUENT||0||January 19, 2006 15:04|