 |
 |
 |
|
|
|
[Sponsors] | ||||
January 18, 2011, 22:22
|
Forcing sHM to produce hex only meshes?
|
#1 |
|
Member
Join Date: Mar 2009
Location: Sydney, New South Wales, Australia
Posts: 42
Rep Power: 6  |
I have seen this problem asked a number of times, but there seems to be no satisfactory answer that I can find. (Perhaps this is because it doesn't exist).
I would like to use my snappy generated meshes with interDyMFoam, but the presence of polyhedra within the mesh prevents the dynamic refinement by the hexRef8 code. So, is there any way to force sHM to produce meshes that contain only hexahedra for use with the dynamic solvers? I have looked through the snappyHexMeshDict, but there is nothing obvious. Is there something I am missing? Cheers, R |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| This mesh contains patches of type empty but is not 1D or 2D | oric | OpenFOAM Running, Solving & CFD | 34 | May 28, 2013 09:42 |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
| [ICEM] how can i create a consistent transitions between tet and hex? specifically my model? | snailstb | ANSYS Meshing & Geometry | 3 | March 15, 2010 21:26 |
| Why are hex meshes better than tet? | bigphil | OpenFOAM Meshing Format & General Technical | 9 | May 19, 2009 05:45 |
| CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 03:34 |
Linear Mode
