|April 27, 2011, 03:56||
Persistent problem with locationInMesh in for snappy
Join Date: Mar 2011
Posts: 2Rep Power: 0
Hi I've been using the forums for a while now but this is my first post.
I'm tearing my hair out trying to get my snappyHexMesh to work but I'm getting the following persistent error:
--> FOAM FATAL ERROR:
Point (4.13 4.91 9.95) is not inside the mesh or on a face or edge.
Bounding box of the mesh-30 -5 0) (5 5 10)
From function refinementParameters::findCells(const polyMesh&) const
in file autoHexMesh/autoHexMeshDriver/refinementParameters/refinementParameters.C at line 121.
I've tried a large range of co-ordinate sets for the point without success.
The simulation is for a supersonic landspeed mockup. What is frustrating is that I used a similar setup before, but on a much smaller scale, for a bullet and had no troubles at all.
Really need some help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Incoherent problem table in hollow-fiber spinning||Gianni||FLUENT||0||April 5, 2008 10:33|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|convergence problem||Trushar||Phoenics||5||August 27, 2002 23:40|