[snappyHexMesh] Strange bumb on the surface

vittorio.bissaro · November 3, 2011, 10:56

Some problem when using snappy with boundary layer.
Strange bumbs appears on the surface of the geometry.
(look at the pictures)
Is it a common problem or I just need to choose the right parameters?
(I can add more information if needed)
Thanks a lot

meshUP.jpg

meshTRI.jpg

wyldckat · November 3, 2011, 13:48

Greetings vittorio.bissaro and welcome to the forum!

That looks a bit like the bug reported here: http://www.openfoam.com/mantisbt/view.php?id=309 - but the bug reported there implies that the problem is related to large surfaces without additional feature edges on them.

Can you attach on your next post the "snappyHexMeshDict" file? Also, open the "*.obj" files in ParaView so you can verify what feature edges are being followed.

Any chance you can simplify the geometry to try and isolate the issue? If you can, you can then later use it for reporting it on the bug tracker in the link above.

Best regards,
Bruno

November 3, 2011, 10:56	Strange bumb on the surface	#1
vittorio.bissaro New Member Join Date: Sep 2011 Posts: 5 Rep Power: 14	Some problem when using snappy with boundary layer. Strange bumbs appears on the surface of the geometry. (look at the pictures) Is it a common problem or I just need to choose the right parameters? (I can add more information if needed) Thanks a lot meshUP.jpg meshTRI.jpg

November 3, 2011, 13:48		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,975 Blog Entries: 45 Rep Power: 128	Greetings vittorio.bissaro and welcome to the forum! That looks a bit like the bug reported here: http://www.openfoam.com/mantisbt/view.php?id=309 - but the bug reported there implies that the problem is related to large surfaces without additional feature edges on them. Can you attach on your next post the "snappyHexMeshDict" file? Also, open the "*.obj" files in ParaView so you can verify what feature edges are being followed. Any chance you can simplify the geometry to try and isolate the issue? If you can, you can then later use it for reporting it on the bug tracker in the link above. Best regards, Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Strange Behaviour of Free Surface	talatgokcer	OpenFOAM Running, Solving & CFD	1	March 13, 2016 09:02
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[snappyHexMesh] Add additional boundary layers to complex stl surface	tobijingles	OpenFOAM Meshing & Mesh Conversion	1	October 26, 2011 10:45
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 06:47