|
[Sponsors] |
[Other] mergeMeshes makes wrong oriented faces. why? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 20, 2015, 14:55 |
mergeMeshes makes wrong oriented faces. why?
|
#1 |
Senior Member
M. Montero
Join Date: Mar 2009
Location: Madrid
Posts: 153
Rep Power: 17 |
I am using OF2.3.x. The master and slave zones pass checkMesh with no errors, only some warnings about orthogonaly higher than 70 in some cells.
When the meshes are joined, the checkMesh over the final mesh inform me that there is a cell, only a cell, with wrong oriented faces. How can it be? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 09:23 |
udf error | srihari | FLUENT | 1 | October 31, 2016 14:18 |
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 14:49 |
SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 14:53 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |