 |
 |
 |
|
|
|
[Sponsors] | ||||
[Technical] How to output a series of cells for paraFoam view |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2008, 03:59
|
How to output a series of cells for paraFoam view
|
#1 |
|
New Member
Jia Rui
Join Date: Mar 2009
Posts: 9
Rep Power: 17  |
Now I can acquire a List, which include all labels of cells I need. How I can output this List to some directory, e.g. constant/polyMesh/set, for paraFoam to observe these cells directly?
I'm eager for any valuable suggestion. |
|
|
|
|
|
December 15, 2008, 04:44
|
i think, you can use utility c
|
#2 |
|
Senior Member
Matvey Kraposhin
Join Date: Mar 2009
Location: Moscow, Russian Federation
Posts: 355
Rep Power: 21 |
i think, you can use utility cellSet for generating list of cells and utility foamToVTK with switch -cellSet, then you can run paraFoam (or paraview)
f.e.: 1) cellSet . case-1 2) foamtToVTK . case-1 -cellSet <setgeneratedonstep1> 3) paraFoam . case-1
__________________
MDPI Fluids (Q2) special issue for OSS software: https://www.mdpi.com/journal/fluids/..._modelling_OSS GitHub: https://github.com/unicfdlab Linkedin: https://linkedin.com/in/matvey-kraposhin-413869163 RG: https://www.researchgate.net/profile/Matvey_Kraposhin |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
| [snappyHexMesh] sHM too many cells | Knapsack | OpenFOAM Meshing & Mesh Conversion | 2 | July 8, 2017 07:41 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
| [snappyHexMesh] snappyHexMesh Segmentation Fault | avd28 | OpenFOAM Meshing & Mesh Conversion | 11 | May 11, 2015 20:32 |
| writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 06:16 |
Linear Mode
