CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing Format & General Technical (http://www.cfd-online.com/Forums/openfoam-meshing-technical/)
-   -   3D mesh with boundary layer (http://www.cfd-online.com/Forums/openfoam-meshing-technical/61932-3d-mesh-boundary-layer.html)

fra76 May 21, 2006 03:32

Hi! I need to generate a quit
 
Hi!
I need to generate a quite complex 3D mesh, with prismatic boundary layer on some surface.
As the ratio between width and height of boundary layer cells is about 7/1, the pyramid/tet mesh growing froma the side of such boundary layer can be of very poor quality. Moreover, the meshing algorithm could even fail in such situation.
Is there an alternative way to deal with this kind of meshes?
Francesco


All times are GMT -4. The time now is 04:35.