Using stitchmesh on imported gmsh meshes
Dear all,
can anybody help me on how the stitchmesh utility works ? I've tried to create a hex gmsh mesh in order to understand. The mesh has been imported with gmshToFoam and the patches created look quite reasonable in paraFoam. Executing "stitchmesh . stitchtest patch4 patch3 -partial" leads to an error message "--> FOAM FATAL ERROR : Face 3683 reduced to less than 3 points. Topological/cutting error B. Old face: 1(10) new face: 1(10) I'll try to attach the case here. Any help is appreciated. Christian http://www.cfd-online.com/OpenFOAM_D...hment_icon.gif stitchtest.tar.gz |
All times are GMT -4. The time now is 14:35. |