bubble in blockmesh
Hi !
I have tried to make a hole in 3d, I mean like a air bubble in water. But I have got a strange error message from blockmesh. What I really try to so is a aircraft in a virtual wind tunnel there the bubble is the aircraft. Have any one tried to do some thing like this? Are there any other solutions on this problem? |
Maybe there is a solution if you give us some detail on the error message.
|
Hi!
I'm trying with different node order on the inner face. look at the picture that I'm made in gmsh to make the work it easier. http://www.tooslow.net/rattus/cfdonline/MshBubble.gif And here is the output from bash. http://www.tooslow.net/rattus/cfdonl...hTestrun_1.txt Here is the blockMeshDict http://www.tooslow.net/rattus/cfdonline/blockMeshDict As you can see, I have tried to make the inner walls oriented the other way around The case is a modify /home/rickard/OpenFOAM/rickard-1.5/run/tutorials/icoFoam/cavity Regards / Rickard Hidefjäll |
You can see at
http://www.tooslow.net/rattus/cfdonl...el20090305.jpg http://www.tooslow.net/rattus/cfdonl...20090305_2.jpg http://www.tooslow.net/rattus/cfdonl...20090305_3.jpg http://www.tooslow.net/rattus/cfdonl...20090305_4.jpg what I try to do. This is done in Gmsh. But I can't find any solution that takes gmsh mesh. OpenFoam can convert it but only with gmsh1.*. And I've tried to complie Gmsh2ToFoam but my it dont work with OF 1.5. |
All times are GMT -4. The time now is 11:13. |