CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Mesh Utilities (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/)
-   -   refineMesh Cylinder (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/106207-refinemesh-cylinder.html)

dl6tud August 22, 2012 00:49

refineMesh Cylinder
 
1 Attachment(s)
I would like to refine a blockmesh. But only an inner cylindrical part. In my opinion, refineMesh does not work properly, because it connects some cells wrong (see picture). Has anyone had the same problem and/or can suggest a solution?

lindstroem August 22, 2012 04:38

If you switch of "decompose polyhedral cells" in paraview, it will look nicer. But you can trust the refineMesh - the mesh is ok. Or did checkMesh complain about something?

Greetings

dl6tud August 22, 2012 06:43

CheckMesh does not complain, so probably you are right. But it is still strange, why some cells are drawn wrong.

lindstroem August 22, 2012 08:38

As said, try to look at it with the option "decompose polyhedral cells".. It'll look fine then..


All times are GMT -4. The time now is 14:11.