CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Mesh Utilities (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/)
-   -   Duplicate point found in cut face - stitchMesh - problem (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/110380-duplicate-point-found-cut-face-stitchmesh-problem.html)

RugbyGandalf December 10, 2012 05:54

Duplicate point found in cut face - stitchMesh - problem
 
Dear Foam-Community,

i am facing the following error, using stitchMesh:

"Duplicate point found in cut face. Error in the face cutting algorithm for global face 4(1199 ...)"

I generated a mesh, using blockMesh, consisting of three regions. Therefore duplicated points are necessary, to define those regions through different blocks (same with the accompanying patches). There are two meshes, i need to merge and stitch. To stitch them, I used the "createPatch"-tool, to form one inlet- and outlet-patch from three (caused by three regions).
Merging is fine, stitching produces the mentioned error.

Does anyone have an idea, how to solve this problem?

Regards,

Martin

ignacio May 15, 2013 05:23

Hello Martin,

I have the same problem. Three regions and the error message of Duplicate points when I try to stitch the faces.
Did you find out how to solve it?

Thanks,

Ignacio


All times are GMT -4. The time now is 07:50.