|August 22, 2013, 08:40||
strange result with blockMesh and checkMesh
Join Date: Jul 2013
Posts: 2Rep Power: 0
I'am a beginner with OF, and try to mesh a square pipe with two inlets and two oulets.
At the junction points I use hex with block with 5 faces like user guide 5.3.3 creating blocks with fewer than 8 vertices.
I test the mesh block by block from inlet to oulet. With 2 inlets, 1 oulet no problem, the junction is correctly meshed with prism and hex.
After I add the second junction with the same technic of meshinig, checkMesh find skewFaces and zeroAreaFaces.
I change unit from m to mm, coordinates to have all positives, look forum but I dont understand why I obtain these bad Faces ?
I add my blockMeshDict file zipped, it contains more vertice than necessary because I keep only the part with problems.
If you have any idea, thank you for helping...
|Thread||Thread Starter||Forum||Replies||Last Post|
|CheckMesh fails when cyclic boundaries are defined - OF 2.2.0||caduqued||OpenFOAM Meshing & Mesh Conversion||2||May 21, 2013 18:31|
|BlockMesh CheckMesh error Help!!!||deepaktbabu||OpenFOAM||0||March 11, 2012 13:40|
|Blockmesh error - 2D scramjet - please help||ishaninair||OpenFOAM Native Meshers: blockMesh||7||March 18, 2011 01:14|
|Face orientation in blockMesh||WiWo||OpenFOAM||0||March 18, 2010 12:10|
|Problem with blockMesh and cyclics||mattijs||OpenFOAM Native Meshers: blockMesh||1||May 26, 2006 06:41|