CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [mesh manipulation] RefineMesh prims not split in the middle of the edge (https://www.cfd-online.com/Forums/openfoam-meshing/61507-refinemesh-prims-not-split-middle-edge.html)

anfromm January 5, 2009 12:37
RefineMesh prims not split in the middle of the edge
 
Hi everyone,

i have a problem with the refineMesh utility refining a prismatic mesh for a 2 dimensional axi-symmetric case. I have set the useHexTopology true, but the prisms at the center are not splitted in the middle of the edge.

http://www.cfd-online.com/OpenFOAM_D...es/1/10516.png

Any idea, how i can solve this?

regards
Andreas

KMM080 April 30, 2019 11:44
Quote:
Originally Posted by anfromm (Post 200096)
Hi everyone,

i have a problem with the refineMesh utility refining a prismatic mesh for a 2 dimensional axi-symmetric case. I have set the useHexTopology true, but the prisms at the center are not splitted in the middle of the edge.

http://www.cfd-online.com/OpenFOAM_D...es/1/10516.png

Any idea, how i can solve this?

regards
Andreas

Hi Andreas,
Have you solved the problem?

Regards,
Kawa


All times are GMT -4. The time now is 16:42.