CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Mesh Utilities (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/)
-   -   Refining mesh in engineFoam (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/61513-refining-mesh-enginefoam.html)

johan November 26, 2008 08:50

Hi everybody, I just wonder
 
Hi everybody,

I just wonder if anyone knows how to refine the mesh within a specific area (close to the ignition site) in the engineFoam/KivaTest tutorial.

Thanks in advance,

Johan

johan December 2, 2008 04:58

Hi again, I mean, I need a
 
Hi again,

I mean, I need a very fine mesh around the ignition site to be able to continue on my thesis work. Is it possible to produce a blockMeshDict and implement it into the geometry of the cylinder in the engineFoam/kivaTest tutorial? Or is there any other way to do it?

There must be a way to refine the mesh around the ignition site, or I really hope so..

Anyone who knows anything or has any suggestions is very welcome to reply.

Thanks,

Johan


All times are GMT -4. The time now is 03:34.