CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Mesh Utilities (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/)
-   -   SnappyHexMesh One instead of two zones (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/61521-snappyhexmesh-one-instead-two-zones.html)

bastil November 5, 2008 08:54

Hi all, I run snappyHexMesh
 
Hi all,

I run snappyHexMesh on a fairly complex geometry. However, the geometry (triangular surface mesh) is 100% closed and manyfold as it has been used for t-grid before. Snappyhexmesh always produces one cell zone wich is inside and outside of my geometry. However I expect only the outside part to be kept.
This means snappy thinks my geometry has a hole, right? How can I find the problematic area in the surface?

Thanks BastiL


All times are GMT -4. The time now is 00:40.