[snappyHexMesh] SnappHexMesh Mesh creating a Mesh inside a Cylinder?

abu · February 15, 2011, 04:39

Hi,

i just started to work with Openfoam and SnappyHexMesh. I read some basic tutorials about OpenFoam and Shm.

So i started to do some meshing, but unfortunaly it didnt worked out that well

my Problem is, that i created a Mesh between a simple cylinder and the surrounding blockmesh, but i want to create a mesh of the inside.

The Cylinder is a simple stl export of Salome with jut one Face.

When i set the Value of locationInMesh into the stl geometrie i get an error: " Point is not loacetd in Mesh"

What am i doing wrong? Do i have to change the SHM.dict or the STL file?

Thx

manuelffonseca · April 4, 2017, 09:57

Hi abu, did you try with another point, maybe the point you had tried was located in the mesh surface..

February 15, 2011, 04:39	SnappHexMesh Mesh creating a Mesh inside a Cylinder?	#1
abu New Member Join Date: Feb 2011 Posts: 1 Rep Power: 0	Hi, i just started to work with Openfoam and SnappyHexMesh. I read some basic tutorials about OpenFoam and Shm. So i started to do some meshing, but unfortunaly it didnt worked out that well my Problem is, that i created a Mesh between a simple cylinder and the surrounding blockmesh, but i want to create a mesh of the inside. The Cylinder is a simple stl export of Salome with jut one Face. When i set the Value of locationInMesh into the stl geometrie i get an error: " Point is not loacetd in Mesh" What am i doing wrong? Do i have to change the SHM.dict or the STL file? Thx Mahyar Javidi likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Create Cylinder (HOLLOW NO MESH OR CAVITY) inside a Cuboid	saddy	OpenFOAM Meshing & Mesh Conversion	5	August 8, 2023 07:10
Forces Acting on a Rotating Cylinder (Moving Mesh)	dreamchaser	CFX	5	April 25, 2015 06:01
[snappyHexMesh] Layers:problem with curvature	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	10	August 22, 2012 09:03
dynamic mesh prob inside the cylinder	kantharao	FLUENT	0	May 30, 2008 06:36
how to mesh cylinder inside the square duct	kathir	Siemens	1	August 1, 2006 08:44

April 4, 2017, 09:57		#2
manuelffonseca New Member Manuel Fermin Fonseca Join Date: Nov 2014 Location: Valencia, Venezuela Posts: 18 Rep Power: 11	Hi abu, did you try with another point, maybe the point you had tried was located in the mesh surface..