|
[Sponsors] |
April 28, 2011, 06:07 |
faceSet utility
|
#1 |
New Member
Juanito
Join Date: Oct 2010
Posts: 27
Rep Power: 15 |
Hi everybody
I want to share my problem in order to somebody can help me. I want to select some faces of my mesh in order to set a cyclic type patch. I use the following makeZones file: faceSet fan new boxToFace (x y z) (x y z)and then I run the following command: setSet -batch makeZonesThe result of this instruction is shown in attached file. You can see that there are two different colors, and when I run the case, the cyclic patch has different effects as if it had different sign. Of course, I would like this don't happen. Any suggestion? Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
[Commercial meshers] faceSet of a cutting plane for a internal patch definition | RubenGutiii | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2019 05:10 |
Something doens't work with wallHeatFlux utility or externalWallHeatFluxTemperat BC!! | zfaraday | OpenFOAM Post-Processing | 0 | February 5, 2015 16:47 |
[swak4Foam] Mass flow rate through faceSet using swak4foam | CedricVH | OpenFOAM Community Contributions | 5 | May 4, 2012 07:57 |
faceSet utility | Aerospace | OpenFOAM | 0 | April 29, 2011 04:20 |