CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Mesh Utilities (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/)
-   -   using mergeMeshes and stitchMesh (http://www.cfd-online.com/Forums/openfoam-meshing-utilities/93361-using-mergemeshes-stitchmesh.html)

Lada October 12, 2011 13:42

using mergeMeshes and stitchMesh
 
I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together.
Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running.
Could anyone give me a hint and/or write here the right procedure, please?

tomislav_maric October 13, 2011 02:25

Quote:

Originally Posted by Lada (Post 327708)
I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together.
Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running.
Could anyone give me a hint and/or write here the right procedure, please?


I've written up the procedure in this thread:

http://www.cfd-online.com/Forums/ope...hes-p-t-u.html

Hope it helps!

Tomislav

Lada October 13, 2011 15:04

That was it. Thank you Tomislav.
Lada


All times are GMT -4. The time now is 16:21.