CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   converting interfaces to ami (http://www.cfd-online.com/Forums/openfoam-meshing/107535-converting-interfaces-ami.html)

atoof September 30, 2012 08:33

converting interfaces to ami
 
Dears,

Can I convert a gambit mesh to OF2.1.x and then change the interface boundaries that defined in gambit to the ami bounadries in the boundary dictionary. I want to use it for dynamic mesh in OF.

Best Regard,

Hossein

hz283 March 9, 2013 20:16

Hi Hossein,

Have you solved that problem you mentioned in the thread? I have the same problem. I generated the mesh for multiply bodies (multiply bodies) using ICEM. The interfaces between neighboring bodies have non matched grid nodes. So I would like to use AMI but the interface itself does not move during the simulations. Do you know how to convert the interface into AMI in openfoam?

best regards,
H

Quote:

Originally Posted by atoof (Post 384246)
Dears,

Can I convert a gambit mesh to OF2.1.x and then change the interface boundaries that defined in gambit to the ami bounadries in the boundary dictionary. I want to use it for dynamic mesh in OF.

Best Regard,

Hossein


A.Wendy April 24, 2013 05:15

never used a gambit mesh before but can't you just modify the boundary file in contant/polymesh and the U,p, etc files in the 0 folder in a text editor?
maybe you can upload these files and i can try?

Andreas


All times are GMT -4. The time now is 16:44.