CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   axisymmetric Mesh generation in Salome (http://www.cfd-online.com/Forums/openfoam-meshing/112815-axisymmetric-mesh-generation-salome.html)

AbbasRahimi February 5, 2013 21:25

axisymmetric Mesh generation in Salome
 
1 Attachment(s)
Hello,

Actually I have generated a terahedral in Salome and everything went well. Also I used that mesh to simulate few cases in OpenFoam which was awesome. However I'm trying now to generate a hexahedral mesh in Salome but I face to error that each faces has more than 4 edges. I tried to fix this problem but it took me few days and yet I'm not successful in that. I wonder if any one can give me some hints.

Thank you.

RGoersch May 24, 2013 09:36

Hi Abbas,

could you send me your Salome dump file so I can take a look on your problem?


All times are GMT -4. The time now is 09:07.