axisymmetric Mesh generation in Salome

AbbasRahimi · February 5, 2013, 20:25

Hello,

Actually I have generated a terahedral in Salome and everything went well. Also I used that mesh to simulate few cases in OpenFoam which was awesome. However I'm trying now to generate a hexahedral mesh in Salome but I face to error that each faces has more than 4 edges. I tried to fix this problem but it took me few days and yet I'm not successful in that. I wonder if any one can give me some hints.

Thank you.

RGoersch · May 24, 2013, 09:36

Hi Abbas,

could you send me your Salome dump file so I can take a look on your problem?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using Salome for mesh generation	MatP	Open Source Meshers: Gmsh, Netgen, CGNS, ...	12	August 30, 2012 01:46
Layers:problem with curvature	giulio.topazio	OpenFOAM Native Meshers: snappyHexMesh and Others	10	August 22, 2012 09:03
[ANSYS Meshing] Question about mesh generation learning	lnk	ANSYS Meshing & Geometry	2	July 7, 2012 06:45
Axisymmetric 2D mesh adaptation - ERROR	Pepe	CFX	3	May 30, 2011 08:28
Problem with quasi-2d axisymmetric mesh	Chrsty	CFX	3	May 8, 2011 08:12

May 24, 2013, 09:36		#2
RGoersch New Member Rafael Goersch Join Date: Feb 2013 Location: Brazil Posts: 3 Rep Power: 2	Hi Abbas, could you send me your Salome dump file so I can take a look on your problem?