[Salome] axisymmetric Mesh generation in Salome

AbbasRahimi · February 5, 2013, 20:25

Hello,

Actually I have generated a terahedral in Salome and everything went well. Also I used that mesh to simulate few cases in OpenFoam which was awesome. However I'm trying now to generate a hexahedral mesh in Salome but I face to error that each faces has more than 4 edges. I tried to fix this problem but it took me few days and yet I'm not successful in that. I wonder if any one can give me some hints.

Thank you.

RGoersch · May 24, 2013, 09:36

Hi Abbas,

could you send me your Salome dump file so I can take a look on your problem?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh Generation in Salome	Raza Javed	Main CFD Forum	8	April 25, 2019 07:08
chtmultiregionfoam: Mesh generation( Salome) and conversion	shiromaniac	OpenFOAM Pre-Processing	2	January 24, 2019 00:18
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 18:57
[Salome] Using Salome for mesh generation	MatP	OpenFOAM Meshing & Mesh Conversion	12	August 30, 2012 01:46
[ANSYS Meshing] Question about mesh generation learning	lnk	ANSYS Meshing & Geometry	2	July 7, 2012 06:45

May 24, 2013, 09:36		#2
RGoersch New Member Rafael Goersch Join Date: Feb 2013 Location: Brazil Posts: 3 Rep Power: 13	Hi Abbas, could you send me your Salome dump file so I can take a look on your problem?