CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   sprayfoam error after some time steps (http://www.cfd-online.com/Forums/openfoam-meshing/118105-sprayfoam-error-after-some-time-steps.html)

azborals May 21, 2013 05:21

sprayfoam error after some time steps
 
hallo everyone,

i tried to run a complex case by sprayFoam. it is an intake port bei an gasoline engine withe valves and cylinder, but there is no movement. i want to get ssteady flowfield and then i want to start the injection. but after some time steps the case stopped because of very a very high velocity and temperatur in a cell near the inlet. can i repair or delete the cell.

thank you!


All times are GMT -4. The time now is 15:08.