 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2013, 08:55
|
good mesher for OpenFoam
|
#1 |
|
New Member
Hao Wang
Join Date: Aug 2013
Posts: 14
Rep Power: 12  |
Dear all,
I am tried of trying different grid sizes via Gmsh. Due to the sharp edges, actually I am not sure, I always got floating point exceptions. Well I check some websites to see if there are some alternatives and I got a few: Blender + Snappyhexmesh Salome ... I was wondering which one is the most stable for OF. I need to generate mesh for channels or maybe insert some coastal structures as objects. The most important thing is where I can find a proper tutorial? I keep on searching now. Hope to get some ideas from you. Thanks! regards, Hao |
|
|
|
|
|
October 14, 2013, 02:55
|
|
#2 |
|
Senior Member
|
Hi,
http://openfoamwiki.net/index.php/GUI list commercial and free Preprocessors http://openfoamwiki.net/index.php/SnappyHexMesh snappy is not bad for Terrain tasks Helyx OS is a free Gui and some free training material from 8th OF workshop http://www.openfoamworkshop2013.org/...ielCombest.tar http://www.openfoamworkshop2013.org/...ielCombest.tar |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parameters of a good airfoil mesh | CharlieBra7o | Mesh Generation & Pre-Processing | 4 | November 20, 2018 14:42 |
| [ICEM] 2D Airfoil Patch Dependent Mesher Ignores Curve Sizing | khoopes | ANSYS Meshing & Geometry | 0 | February 2, 2013 10:28 |
| How to do a good geometry clean-up in GAMBIT | mahadevan.swamy | Main CFD Forum | 0 | June 19, 2009 21:13 |
| Good convergence but without a good heat balance | Juan Martin Catelén | CFX | 4 | June 27, 2007 18:41 |
| [blockMesh] Is blockMesh generally considered a good quality tool | york | OpenFOAM Meshing & Mesh Conversion | 4 | November 15, 2006 13:42 |
Linear Mode
